Canon MK 2600 Mk2600 Users Guide - Page 105
Press [Adjust]., to select Length adjust
View all Canon MK 2600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
6 Input character data in accordance with conditions. • "Changing character size" ( page 68) • "Changing the spacing between characters" ( page 69) Advanced Operations Part 4 7 Perform the printing operation. Character Character size space Changing segment length of all pages If "All" is selected on the Seg Length selection display, characters typed exceeding the specified segment length are deleted. If 2.00 mm is specified as the segment length, all characters are deleted even when a page containing "6mm 100%" characters exists. For this page, 2.00 mm is temporarily specified as the segment length and "6mm 100%" is temporarily specified as the character size and therefore you cannot enter any character. Select "Automatic" on the Seg Length selection display or change the character size before entering characters. It is recommended that you save the file before selecting "All" on the Cut Length selection display. Expanding the Plate Printing Area For the procedure to follow after selecting "Expansion" on the Plate Printing Area selection display, refer to "Printing with short pitch width" ( page 111). Adjusting the segment length You can adjust the set segment length by ±5%. 1. Press [Adjust]. • The Print Media selection display appears. 2. Press [▲] or [▼] to select the print media, and then press [Enter]. • Press [Enter] to display the Adjustments display. This segment length adjustment is intended for use with labels, and may not produce the corresponding effect with other media. 3. Press [▲] or [▼] to select "Length adjust", and then press [Enter]. • The Length adjust selection display appears. 101