Cisco NAC3350-PROF-K9 Hardware Installation Guide - Page 70
Downloading Cisco NAC Appliance Software, Upgrading Firmware
View all Cisco NAC3350-PROF-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
Upgrading Firmware Chapter 2 Preparing for Installation Downloading Cisco NAC Appliance Software You can access the latest versions of the Cisco NAC Appliance Release 4.8(x) installation .ISO file as follows. Caution Before downloading or installing any Cisco NAC Appliance software, make sure to refer to the Release Notes for Cisco NAC Appliance, corresponding to your latest Cisco NAC Appliance release version, to understand the enhancements, caveats, and upgrade impact to your existing deployment. Step 1 Step 2 Step 3 Log in to the Cisco Software Download Site at http://www.cisco.com/public/sw-center/index.shtml. You will likely be required to provide your CCO credentials. Navigate to Security > Endpoint Security > Cisco Network Access Control > Cisco NAC Appliance > Cisco NAC Appliance 4.8. Download the latest 4.8(x) .ISO image (e.g. nac-4.8-K9.iso) and burn the image as a bootable disk to a CD-R. Note Cisco recommends burning the .ISO image to a CD-R using speeds 10x or lower. Higher speeds can result in corrupted/unbootable installation CDs. Upgrading Firmware Cisco NAC Appliance CAMs/CASs are subject to any system BIOS/Firmware upgrades required for the server model on which they are based. • The NAC-3315 is based on the IBM System x3250 M2 server platform and the NAC-3355/3395 are based on the IBM System x3550 M2 server platform. • The NAC-3310 is based on the HP ProLiant DL140 G3 server platform and the NAC-3350/3390 are based on the HP ProLiant DL360 G5 server platform. Note For Cisco NAC-3310 platforms, be sure to also refer to the "DL140 G3 Required BIOS/Firmware Upgrades" section of the Supported Hardware and System Requirements for Cisco NAC Appliance (Cisco Clean Access) for further details. 2-28 Cisco NAC Appliance Hardware Installation Guide OL-20326-01