D-Link DGS-1510-20 User Manual - Page 131

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide Group Address Unit From Port / To Port VID Group Address Enter an IPv6 multicast group address. Select the switch unit that will be used for this configuration here. Select the appropriate port range used for the configuration here. Click the radio button and enter a VLAN ID of the multicast group. Click the radio button and enter an IP multicast group address. Click the Apply button to accept the changes made. Click the Delete button to remove the specified entry. Click the Find button to locate a specific entry based on the information entered. Click the Find All button to view all the entries. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. The fields that can be configured for MLD Snooping Groups Table are described below: Parameter VID Group Address Description Click the radio button and enter a VLAN ID of the multicast group. Click the radio button and enter an IP multicast group address. Click the Find button to locate a specific entry based on the information entered. Click the Find All button to view all the entries. MLD Snooping Mrouter Settings This window is used to configure the specified interface(s) as the router ports or forbidden to be IPv6 multicast router ports on the VLAN interface on the Switch. To view the following window, click L2 Features > L2 Multicast Control > MLD Snooping > MLD Snooping Mrouter Settings, as shown below: Figure 5-47 MLD Snooping Mrouter Settings window The fields that can be configured for MLD Snooping Mrouter Settings are described below: Parameter VID Configuration Description Enter a VLAN ID between 1 and 4094. Select the port configuration. Options to choose from are Port, Forbidden Port, and Learn pimv6. 123