D-Link DGS-1510-20 User Manual - Page 199
Sequence No., Auto Assign
View all D-Link DGS-1510-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 199 highlights
DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide IP Precedence ToS DSCP Time Range Action from are Any, Host, and IP. When the Any option is selected, any destination traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the destination host's IP address here. When the IP option is selected, the Wildcard option will also be available. Enter the group of destination IP addresses by using a wildcard bitmap. The bit corresponding to the bit value 1 will be ignored. The bit corresponding to the bit value 0 will be checked. Select the IP precedence value used here. Options to choose from are 0 (routine), 1 (priority), 2, (immediate), 3 (flash), 4 (flash-override), 5 (critical), 6 (internet), and 7 (network). After selecting the IP precedence value, select the Type-of-Service (ToS) value that will be used here. Options to choose from are 0 (normal), 1 (min-monetary-cost), 2 (max-reliability), 3, 4 (maxthroughput), 5, 6, 7, 8 (min-delay), 9, 10, 11, 12, 13, 14, and 15. Select or enter the DSCP value used here. This value must be between 0 and 63. Enter the name of the time range to associate with this ACL rule. Select the action that this rule will take here. Options to choose from are Permit and Deny. Click the Back button to return to the previous window. Click the Next button to continue. After clicking the IPv6 radio button and the Next button, the following window will appear. Figure 8-20 ACL Configuration Wizard (Add Rule for IPv6 ACL) window This window has a dynamic section. Every selection made in the Protocol Type drop-down list will change the bottom part of this window. The fixed fields that can be configured are described below: Parameter Sequence No. Protocol Type Description Enter the ACL rule number here. This value must be between 1 and 65535. Select Auto Assign to automatically generate an ACL rule number for this entry. Select the protocol type option here. Options to choose from are TCP, 191