D-Link DGS-1510-20 User Manual - Page 428
Access Control List ACL Commands, Access Control List
View all D-Link DGS-1510-20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 428 highlights
DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide The table below shows the definition of Tag field (different with RFC 2868): Tag field value 0x01 0x02 Others (0x00, 0x03 ~ 0x1F, >0x1F) String field format VLAN name (ASCII) VLAN ID (ASCII) When the switch receives the VLAN setting string, it will think it is the VLAN ID first. In other words, the switch will check all existing VLAN IDs and check if there is one matched. If the switch can find one matched, it will move to that VLAN. If the switch cannot find the matched VLAN ID, it will think the VLAN setting string as a "VLAN Name". Then it will check that it can find out a matched VLAN Name. NOTE: A tag field of greater than 0x1F is interpreted as the first octet of the following field. If the user has configured the VLAN attribute of the RADIUS server (for example, VID 3), and the 802.1X, MAC-based Access Control, JWAC or WAC authentication is successful, the port will be assigned to VLAN 3. However if the user does not configure the VLAN attributes, when the port is not guest VLAN member, it will be kept in its current authentication VLAN, and when the port is guest VLAN member, it will be assigned to its original VLAN. To assign the ACL by the RADIUS server, the proper parameters should be configured on the RADIUS server. The table below shows the parameters for an ACL. The parameters of the Vendor-Specific Attribute are: RADIUS Tunnel Attribute Vendor-ID Vendor-Type Attribute-Specific Field Description Defines the vendor. Defines the attribute. Used to assign the ACL script. The format is based on Access Control List (ACL) Commands. Value Usage 171 (DLINK) Required 14 (for ACL script) Required ACL Script For example: ip access-list a1;permit host 10.90.90.100;exit; mac access-list extended m1;permit host 00-00-00-01-90-10 any; exit; Required If the user has configured the ACL attribute of the RADIUS server (for example, ACL script: ip access-list a1;permit host 10.90.90.100;exit; mac access-list extended m1;permit host 00-00-00-01-90-10 any; exit;), and the 802.1X, MAC-based Access Control, JWAC or WAC authentication is successful, the device will assign the ACL script according to the RADIUS server. The enter Access-List Configuration Mode and exit Access-List Configuration Mode must be a pair, otherwise the ACP script will be reject. For more information about the ACL module, please refer to Access Control List (ACL) Commands chapter. 420