D-Link DGS-1510-20 User Manual - Page 242

DGS-1510 Series Gigabit Ethernet SmartPro Switch Web UI Reference Guide from are and Range. When selecting the = option, the specific selected port number will be used. When selecting the > option, all ports greater than the selected port, will be used. When selecting the < option, all ports smaller than the selected port, will be used. When selecting the ≠ option, all ports, excluding the selected port, will be used. When selecting the Range option, the start port number and end port number selected, of the range, will be used. Alternatively, the port number(s) can manually be entered in the space(s) provided, if the port number(s) is/are not available in the drop-down list. DSCP Select or enter the DSCP value used here. This value must be between 0 and 63. Flow Label Time Range Enter the flow label value here. This value must be between 0 and 1048575. Enter the name of the time range to associate with this ACL rule. After selecting the ICMP option as the Protocol Type, the following page and parameters will be available, as shown below: Figure 8-69 Extended IPv6 ACL (Add Rule) ICMP window The dynamic fields that can be configured are described below: Parameter Source Destination Description Select and enter the source information here. Options to choose from are Any, Host, and IPv6. When the Any option is selected, any source traffic will be evaluated according to the conditions of this rule. When the Host option is selected, enter the source host's IPv6 address here. When the IPv6 option is selected, the Prefix Length option will also be available. Enter the source IPv6 address and prefix length value in the spaces provided. Select and enter the destination information here. Options to choose from are Any, Host, and IPv6. When the Any option is selected, any 234