D-Link DGS-3620-52P CLI Guide - Page 133
config arp_aging time, show arpentry
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 133 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide DGS-3620-28SC:admin# 7-4 config arp_aging time Description This command is used to set the maximum amount of time, in minutes, that an ARP entry can remain in the switch's ARP table, without being accessed, before it is dropped from the table. Format config arp_aging time Parameters - The ARP age-out time, in minutes. The default is 20 minutes. The range is 0 to 65535 minutes. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure the ARP aging time: DGS-3620-28SC:admin#config arp_aging time 30 Command: config arp_aging time 30 Success. DGS-3620-28SC:admin# 7-5 show arpentry Description This command is used to display the Address Resolution Protocol (ARP) table. Filter the display by IP address, interface name, static entries or mac_address. Format show arpentry {ipif | ipaddress | static | mac_address } Parameters ipif - The name of the IP interface the end node or station for which the ARP table entry was made, resides on. - Specify the IP interface name. The maximum length is 12 characters. ipaddress - The IP address of the end node or station. - Specify the IP address. 128