D-Link DGS-3620-52P CLI Guide - Page 525
enable ip_tunnel
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 525 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide Parameters - (Optional) Enter the IP tunnel interface name used here. This name can be up to 12 characters long. Restrictions None. (EI Mode Only Command) Example To show an IP tunnel interface's information (Tunnel name is "tn2"): DGS-3620-28SC:admin# show ip_tunnel tn2 Command: show ip_tunnel tn2 Tunnel Interface Interface Admin State Tunnel Mode IPv6 Address Tunnel Source Tunnel Destination : tn2 : Enabled : Manual : 2000::1/64 : 1.0.0.1 : 1.0.0.2 DGS-3620-28SC:admin# 44-7 enable ip_tunnel Description This command is used to enable a single specified IP tunnel or all IP tunnels on the Switch. Format enable ip_tunnel {} Parameters - (Optional) Enter the IP tunnel interface name used here. This name can be up to 12 characters long. Restrictions Only Administrator, Operator and Power-User level users can issue this command. (EI Mode Only Command) Example To enable an IP tunnel interface (Tunnel name is "tn2"): 520