D-Link DGS-3620-52P CLI Guide - Page 675
config mld_snooping rate_limit
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 675 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide - Specify the VLAN ID list. all - Specify to configure all VLANs. state - Enable or disable MLD snooping for the chosen VLAN. enable - Enable MLD snooping for the chosen VLAN. disable - Disable MLD snooping for the chosen VLAN. fast_done - Enable or disable the MLD snooping fast leave function. If enabled, the membership is immediately removed when the system receive the MLD leave message. enable - Enable the MLD snooping fast leave function. disable - Disable the MLD snooping fast leave function. proxy_reporting - Specifies that the proxy reporting function will be configured. state - Specifies the state of the proxy reporting function. enable - Specifies that the proxy reporting function will be enabled. disable - Specifies that the proxy reporting function will be disabled. source_ip - Specifies the source IPv6 address used. - Enter the source IPv6 address used here. Restrictions Only Administrator, Operator and Power-User level users can issue this command. Example To configure MLD snooping: DGS-3620-28SC:admin#config mld_snooping vlan_name default state enable Command: config mld_snooping vlan_name default state enable Success. DGS-3620-28SC:admin# 61-2 config mld_snooping rate_limit Description This command is used to configure the upper limit per second for ingress MLD control packets. Format config mld_snooping rate_limit [ports | vlanid ] [ | no_limit] Parameters ports - Specify a range of ports to be configured. - Specify a range of ports to be configured. vlanid - Specify a range of VLANs to be configured. - Specify the VLAN ID list. - Specify the rate limit of MLD control packet that the switch can process on a specific port/VLAN. The rate is specified in packet per second. The packet that exceeds the limited rate will be dropped. no_limit - The default setting is no limit. 670