D-Link DGS-3620-52P CLI Guide - Page 308
debug bgp packet
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 308 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 20-40 debug bgp packet Description This command is used for setting the flag of debugging information about different type of BGP packets' receiving and sending. Format debug bgp packet [{open | update | keepalive | notify | refresh | capability}(1) | all] [in | out] [enable | disable] Parameters packet - Specifies the packet type for the debug information to display. open - (Optional) Specifies that 'open' information will be displayed. update - (Optional) Specifies that 'update' information will be displayed. keepalive - (Optional) Specifies that 'keepalive' information will be displayed. notify - (Optional) Specifies that 'notify' information will be displayed. refresh - (Optional) Specifies that 'refresh' information will be displayed. capability - (Optional) Specifies that 'capability' information will be displayed. all - (Optional) Specifies that all information will be displayed. in - Specifies that the incoming information will be displayed. out - Specifies that the outgoing information will be displayed. enable - Enable the BGP debug function. disable - Disable the BGP debug function. Restrictions Only Administrator-level users can issue this command. (EI Mode Only Command) Example Configure BGP to display debugging information after received update packet: DGS-3620-28SC:admin# debug bgp packet all in enable Command: debug bgp packet all in enable Success. DGS-3620-28SC:admin# Output Examples: After BGP peer FSM event debug flag to enable, it may print following information. 303