D-Link DGS-3620-52P CLI Guide - Page 514
show iproute, create ipv6route
View all D-Link DGS-3620-52P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 514 highlights
xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch CLI Reference Guide 43-3 show iproute Description This command is used to display the switch's current IP routing table. Format show iproute {[ | ]} {[static | rip | ospf | bgp | hardware]} Parameters - (Optional) Specifies the destination network address of the route want to be displayed. - (Optional) Specifies the destination IP address of the route want to be displayed. The longest prefix matched route will be displayed. static - (Optional) Specifies to display only static routes. One static route may be active or inactive. rip - (Optional) Specifies to display only RIP routes. ospf - (Optional) Specifies to display only OSPF routes. bgp - (Optional) Specifies to display only BGP routes. (EI Mode Only Parameter) hardware - (Optional) Specifies to display only the routes that have been written into the chip. Restrictions None. Example To display the contents of the IP routing table: DGS-3620-28SC:admin#show iproute Command: show iproute Routing Table IP Address/Netmask 10.0.0.0/8 Gateway 0.0.0.0 Interface -----------System Cost -------1 Protocol -------Local Total Entries : 1 DGS-3620-28SC:admin# 43-4 create ipv6route Description This command is used to create an IPv6 static route in the switch's IP routing table. If the next hop is a global address, it is not necessary to indicate the interface name. If the next hop is a link local address, then the interface name must be specified. 509