Dell PowerEdge T350 EMC Installation and Service Manual - Page 75
Prerequisites, Steps, Installing the BOSS S2 card carrier blank
![]() |
View all Dell PowerEdge T350 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Figure 62. Installing the BOSS S2 card carrier blank Removing the BOSS S2 module Prerequisites 1. Follow the safety guidelines listed in the Safety instructions. 2. Follow the procedure listed in the Before working inside your system. 3. Remove the front bezel. 4. Disconnect the BOSS S2 power and signal cable from the BOSS S2 module and the system board. Steps 1. Pull and lift the BOSS S2 card carrier retention latch lock to open. 2. Slide the BOSS S2 card carrier out. Installing and removing system components 75
![](/manual_guide/products/dell-poweredge-t350-emc-installation-service-manual-63498c5/75.png)
Figure 62. Installing the BOSS S2 card carrier blank
Removing the BOSS S2 module
Prerequisites
1.
Follow the safety guidelines listed in the
Safety instructions
.
2.
Follow the procedure listed in the
Before working inside your system
.
3.
Remove the front bezel
.
4.
Disconnect the BOSS S2 power and signal cable from the BOSS S2 module and the system board.
Steps
1.
Pull and lift the BOSS S2 card carrier retention latch lock to open.
2.
Slide the BOSS S2 card carrier out.
Installing and removing system components
75