Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 1063

34 The multicast commands are supported by Dell Networking OS on all S3100 series platform. Multicast IPv4 Multicast Commands The following section contains the IPv4 multicast commands. clear ip mroute Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base, use the clear ip pim tib command. Syntax Parameters clear ip mroute [vrf vrf-name] {group-address [source-address] | * | snooping} vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this setting on that VRF. NOTE: Applies to specific VRF if input is provided, else applies to Default VRF. group-address [source-address] * snooping Enter the multicast group address and source address (if desired), in dotted decimal format, to clear information on a specific group. Enter * to clear all multicast routes. Enter the keyword snooping to delete multicast snooping route table entries. Command Modes Command History EXEC Privilege This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Multicast 1063