Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 1247

Example Dell(conf)# ip access-list standard map1 Dell(config-std-nacl)# permit 224.0.0.1/24 Dell(config-std-nacl)# exit Dell(conf)# int gig 1/1 Dell(config-if-gi-1/1)# ip pim ingress-interface-map map1 Dell(config-if-gi-1/1)# ip pim neighbor-filter To prevent a router from participating in protocol independent multicast (PIM), configure this feature. Syntax ip pim [vrf vrf-name] neighbor-filter {access-list} To remove the restriction, use the no ip pim [vrf vrf-name] neighbor-filter {access-list} command. Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to prevent that VRF from participating in PIM. NOTE: Applies to specific VRF if input is provided, else applies to default VRF. access-list Enter the name of a standard access list. Maximum 16 characters. Defaults Command Modes Command History none CONFIGURATION This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.5(0.1) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the C-Series and S-Series. PIM-Sparse Mode (PIM-SM) 1247