Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 1235

Parameters port source-port| source-port-range start-port - end-port} {destination-port destination-port| destination-port-range start-port - end-port} To delete a filter, use the no seq sequence-number command. sequence-number permit redirect ip-address tunnel tunnel-id track track ip-protocol-number protocol-type Enter a number from 1 to 65535. Enter the keyword permit assign the sequence to the permit list. Enter the keyword redirect to assign the sequence to the redirect list. Enter the keyword IP address of the forwarding router. Enter the keyword tunnel to configure the tunnel setting. Enter the keyword tunnel-id to redirect the traffic. Enter the keyword track to enable the tracking. Enter the keyword track to track object-id. Enter the keyword ip-protocol-number then the number from 0 to 255 for the protocol identified in the IP protocol header. Enter one of the following keywords as the protocol type: • icmp for internet control message protocol • ip for any internet protocol • tcp for transmission control protocol • udp for user datagram protocol source mask any host ip-address destination bit Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x). Enter the keyword any to specify that all traffic is subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) For the TCP protocol type only, enter one or a combination of the following TCP flags: • ack = acknowledgement • fin = finish (no more data from the user) • psh = push function • rst = reset the connection • syn = synchronize sequence number • urg = urgent field operator (OPTIONAL) For the TCP and UDP parameters only. Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt= less than Policy-based Routing (PBR) 1235