Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 1234

any host ip-address destination operator Enter the keyword any to specify that all traffic is subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) For TCP and UDP parameters only. Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for theport command parameter.) Defaults Command Modes Command History None REDIRECT-LIST This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.7(0.0) 9.5(0.1) 9.4(0.0) 8.4.2.1 8.4.2.0 7.7.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Added support for the track-id on the S4810, S4820T, S6000, and Z9000. Introduced on the Z9500. Introduced on the S4810, S4820T, S6000, and Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. Introduced on the E-Series. seq Configure a filter with an assigned sequence number for the redirect list. Syntax seq sequence-number {permit | redirect {ip-address | tunnel tunnel-id}[track ] }} {ip-protocol-number | protocol-type} {source mask | any | host ipaddress} {destination mask | any | host ip-address} [bit] [operator]{source- 1234 Policy-based Routing (PBR)