Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 1190

Version 7.5.1.0 pre-6.1.1.1 Description Introduced on the C-Series. Introduced on the E-Series. Usage Information Example Setting the delay and holdtime parameters to a low number enables the switch to an alternate path quickly but requires more CPU usage. Dell# conf Dell(conf)# router ospf 1 Dell(conf-router_ospf-1)# timer spf 2 5 msec Dell(conf-router_ospf-1)# show config ! router ospf 1 timers spf 2 5 msec Dell(conf-router_ospf-1)# end timers throttle lsa all Configure LSA transmit intervals. Syntax timers throttle lsa all {start-interval | hold-interval | max-interval} To return to the default, use the no timers throttle lsa command. Parameters start-interval hold-interval max-interval Set the minimum interval between initial sending and resending the same LSA. The range is from 0 to 600,000 milliseconds. Set the next interval to send the same LSA. This interval is the time between sending the same LSA after the start-interval has been attempted. The range is from 1 to 600,000 milliseconds. Set the maximum amount of time the system waits before sending the LSA. The range is from 1 to 600,000 milliseconds. Defaults • start-interval: 0 msec • hold-interval: 5000 msec • max-interval: 5000 msec Command Modes Command History ROUTER OSPF This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. 1190 Open Shortest Path First (OSPFv2 and OSPFv3)