Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 1254

Version 7.7.1.1 Description Introduced Usage Information This command configures an expiration timer for all S.G entries, unless they are assigned to an Extended ACL. Even though the FHR nodes act as RPs, these nodes still send Register encap messages to themselves and expect to receive a Register stop message (for Anycast RP support). As a result, if the DLT timer expires, SG is not deleted until the register state is deleted in the node. This register state expires 210 seconds after the last Null register is received. ip pim ssm-range Specify the SSM group range using an access list. Syntax ip pim [vrf vrf-name] ssm-range {access_list_name} Parameters vrf vrf-name (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to specify the SSM group range for that VRF. NOTE: Applies to specific VRF if input is provided, else applies to Default VRF. access_list_name Enter the name of the access list. Defaults Command Modes Command History Default SSM range is 232/8 and ff3x/32 CONFIGURATION This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.5(0.1) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.1 8.1.1.0 7.8.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Added support for VRF on S6000, S4810, S4820T, Z9000, Z9500, and S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the S-Series. 1254 PIM-Sparse Mode (PIM-SM)