Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 52

Prompt Interface Type Dell(conf-if)# INTERFACE mode Dell(conf-if- Gigabit Ethernet interface then the slot/port information gi-1/1)# Dell(conf-if- Ten-Gigabit Ethernet interface then slot/port information te-1/1)# Dell(conf-if- Loopback interface number lo-0)# Dell(conf-if- Null Interface then zero nu-0)# Dell(conf-if- Port-channel interface number The range is from 1 to 128. po-0)# Dell(conf-if- VLAN Interface then VLAN number (range 1-4094) vl-0)# Dell(conf-if- Management Ethernet interface then slot/port information ma-1/1)# Dell(conf-if- Tunnel interface then tunnel ID. tu-0)# Dell(conf-if- Designated interface range (used for bulk configuration). range)# IP ACCESS LIST Mode To enter IP ACCESS LIST mode and configure either standard or extended access control lists (ACLs), use the ip access-list standard command or the ip access-list extended command. To enter IP ACCESS LIST mode: 1 Verify that you are logged in to CONFIGURATION mode. 2 Enter either the ip access-list standard command or the ip access-list extended command. Include a name for the ACL. The prompt changes to include conf-std-nacl or conf-ext-nacl. You can return to CONFIGURATION mode by using the exit command. ISIS ADDRESS-FAMILY Mode To enable or configure IPv6 for ISIS, use ISIS ADDRESS-FAMILY mode. For more information, see Intermediate System to Intermediate System (IS-IS). To enter ISIS ADDRESS-FAMILY mode: 1 Verify that you are logged in to ROUTER ISIS mode. 2 Enter the address-family ipv6 unicast command. The prompt changes to include conf-router_isis-af_ipv6. 52 CLI Basics