Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 226

Parameters source mask any host ip-address dscp operator Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host and then enter the IP address to specify a host IP address. Enter the keyword dscp to deny a packet based on the DSCP value. The range is from 0 to 63. (OPTIONAL) Enter one of the following logical operand: • eq = equal to • neq = not equal to • gt = greater than • lt = less than • range = inclusive range of ports (you must specify two ports for the port parameter) port port destination count byte order fragments monitor no-drop Enter the application layer port number. Enter two port numbers if you are using the range logical operand. The range is 0 to 65535. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lowerorder numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). Enter the keyword fragments to use ACLs to control packet fragments. (OPTIONAL) Enter the keyword monitor then the session-ID to describe the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. The session-ID range is from 0 to 65535. For more information, see "Flow-based Monitoring" in the Port Monitoring section of the Dell Networking OS Configuration Guide. Enter the keywords no-drop to match only the forwarded packets. Defaults Command Modes Command History Not configured. CONFIGURATION-EXTENDED-ACCESS-LIST This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.11(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) Description Added support for session-ID to the monitor parameter. Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. 226 Access Control Lists (ACL)