Dell S3100 Command Line Reference Guide for the Series 9.112.1 - Page 213

To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny icmp {source mask | any | host ip-address} {destination mask | any | host ip-address} command. Parameters source mask any host ip-address destination dscp count byte order fragments monitor no-drop Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or non-contiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. Enter this keyword dscp to deny a packet based on the DSCP value. The range is from 0 to 63. (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower order numbers have a higher priority) If you did not use the keyword order, the ACLs have the lowest order by default (255). Enter the keyword fragments to use ACLs to control packet fragments. (OPTIONAL) Enter the keyword monitor then the session-ID to describe the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. The session-ID range is from 0 to 65535. For more information, see Flow-based Monitoring in the Port Monitoring section in the Dell Networking OS Configuration Guide. Enter the keywords no-drop to match only the forwarded packets. Defaults Command Modes Command History Not configured. CONFIGURATION-EXTENDED-ACCESS-LIST This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.11(0.0) 9.10(0.1) 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) Description Added support for session-ID to the monitor parameter. Introduced on the S6010-ON and S4048T-ON. Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Access Control Lists (ACL) 213