Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 1200

Usage Information The router with the largest value assigned to an interface becomes the designated router. If two interfaces contain the same designated router priority value, the interface with the largest interface IP address becomes the designated router. ip pim join-filter Permit or deny PIM Join/Prune messages on an interface using an extended IP access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group. Syntax ip pim [vrf vrf-name] join-filter ext-access-list [in | out] To remove the access list, use the no ip pim [vrf vrf-name] join-filter ext-access-list command. Parameters vrf vrf-name ext-access-list in out (OPTIONAL) Enter the keyword vrf followed by the name of the VRF to permit or deny PIM join or prune messages on an interface associated with that VRF. Enter the name of an extended access list. Enter the keyword in to apply the ACL filter to in-bound traffic. Enterthe keyword out to apply the ACL filter to out-bound traffic. Defaults none Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.5(0.1) 9.0.2.0 8.3.19.0 8.3.11.1 8.3.7.0 8.1.1.0 7.8.1.0 7.7.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Removed the in and out parameters. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Introduced on the E-Series. Introduced on the C-Series for the port-channels and the S-Series. Introduced on the E-Series. PIM-Sparse Mode (PIM-SM) 1200