Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 175

Version 8.3.19.0 8.3.12.0 8.3.11.1 7.6.1.0 7.4.1.0 Description Introduced on the S4820T. Introduced on the S4810. Introduced on the Z9000. Introduced on the C-Series and S-Series. Introduced on the E-Series. Usage Information When you configure the dot1x server-timeout value, take into account the communication medium used to communicate with an authentication server and the number of RADIUS servers configured. Ideally, the dot1x server-timeout value (in seconds) is based on the configured RADIUS-server timeout and retransmit values and calculated according to the following formula: dot1x servertimeout seconds > (radius-server retransmit seconds + 1) * radius-server timeout seconds. Where the default values are as follows: dot1x server-timeout (30 seconds), radius-server retransmit (3 seconds), and radius-server timeout (5 seconds). Example Dell(conf)# radius-server host 10.11.197.105 timeout 6 Dell(conf)# radius-server host 10.11.197.105 retransmit 4 Dell(conf)# interface gigabitethernet 2/23 Dell(conf-if-gi-2/23)# dot1x server-timeout 40 Dell(conf-if-gi-2/23)# dot1x static-mab Enable static MAC authorization bypass (MAB) and configure static MAB profile to an interface. Syntax Parameters [no] dot1x static-mab profile profile-name profile profilename Enter the keyword profile and the profile-name to configure the static MAB profile name. The profile name length is limited to 32 characters. Defaults Disabled. Command Modes INTERFACE INTERFACE (BATCH MODE) Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.10(0.0) 9.9(0.0) Description Introduced on the S3148. Introduced on the S3100 series, S4048-ON, S4048-ON, S4810, S4820T, S5000, S6000, S6000-ON, the Configuration Terminal Batch mode on C9010, Z9100- ON, and Z9500. Introduced on the C9010. 802.1X 175