Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 649

Version 7.6.1.0 7.5.1.0 6.1.1.0 Description Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information When creating an interface range, interfaces appear in the order they are entered; they are not sorted. The command verifies that interfaces are present (physical) or configured (logical). Important Points to Remember: • Bulk configuration is created if at least one interface is valid. • Non-existing interfaces are excluded from the bulk configuration with a warning message. • The interface range prompt includes interface types with slot/port information for valid interfaces. The prompt allows for a maximum of 32 characters. If the bulk configuration exceeds 32 characters, it is represented by an ellipsis When the interface range prompt has multiple port ranges, the smaller port range is excluded from the prompt. • If overlapping port ranges are specified, the port range is extended to the smallest start port and the biggest end port. Example (Bulk) Dell(conf)# interface range gigbitethernet 1/1 - 1/11, tengigabitethernet 3/3, gigbitethernet 3/10 % Warning: Non-existing ports (not configured) are ignored by interface-range Example (Multiple Ports) Dell(conf)# interface range gigabitethernet 2/10 - 2/23, gigabitethernet 2/12 - 2/17 Dell(conf-if-range-gi-2/10-2/23)# Example Dell(conf)# interface range gigabitethernet 2/3 - 2/11, gigabitethernet 2/3 - (Overlapping Ports) 2/23 Dell(conf-if-range-gi-2/3-2/23)# Usage Information Only VLAN and port-channel interfaces created using the interface vlan and interface portchannel commands can be used in the interface range command. Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-channel interfaces that are not displayed in the show running-config command cannot be used with the bulk configuration feature of the interface range command. You cannot create virtual interfaces (VLAN, Port-channel) using the interface range command. NOTE: If a range has VLAN, physical and port-channel interfaces, only commands related to physical interfaces can be bulk configured. To configure commands specific to VLAN and portchannel only those respective interfaces should be configured in a particular range. Example (Single Range) This example shows a single range bulk configuration. Dell(config)# interface range gigabitethernet 5/3 - 23 Dell(config-if-range-gi-5/3-5/23)# no shutdown Dell(config-if-range-gi-5/3-5/23)# Example (Multiple Range) This example shows how to use commas to add different interface types to a range of interfaces. Dell(config-if)# interface range gigabitethernet 5/1 - 5/23, gigabitethernet 1/1 - 1/2 Interfaces 649