Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 1230

Version 9.8(2.0) Description Introduced on the S3100 series. Usage information The power inline [max_milliwatts} command enables inline power supply to an interface. You can specify the maximum amount of power allocation to a device in max-milliwatts from 440 to 30000 mW. If a specific power supply value is not configured, the default value 30,000 mW is configured as the maximum power for allocation to powered devices. You can disable the inline power supply to a port using the no power inline command. The power inline priority command allows you to specify the power inline priority for an interface when a power shortage occurs. PoE is removed from ports configured with low priority first, then ports configured with high priority are disabled. The ports configured with critical priority are the last ports disabled during a power shortage. When two or more ports are configured with same priority level, the ports with higher interface numbers are disabled first. For example, if ports 1, 2, 47, and 48 are all configured with a low priority and there is a shortage of inline power supply, PoE is first disabled on port 48, followed by port 47 and, then port 2. Port 1 (with the lowest interface number) takes precedence over all other ports and is disabled after all other ports are disabled. Example Dell(conf)#interface gigabitethernet 1/1 Dell(conf-if-gi-1/1)#power inline 30000 Dell(conf-if-gi-1/1)#show power inline stack-unit 1 Dell#show power inline stack-unit 1 Global inline power Threshold : 10 Power Reserved for inline Power: 95W Total Inline Power Consumed: 0W Remaining inline power Available: 95W Power Management Mode: Static Interface Inline Power Inline Power Class Device Max / Alloc Consumed Type (Watts) (Watts) Gi 1/1 30.00/0.00 0.00 NO_DEVICE high - Dell# PoE Port Priority -------- - LLDP Support ------ power inline legacy Use this command to allocate inline power to the legacy devices on the specified stack unit. Syntax power inline legacy stack-unit unit number To disable the detection of legacy powered devices in a stack unit, use the no power inline legacy stack-unit unit number command. Parameters stack-unit unit number Enter the keyword stack-unit and the unit number. Range is 1 to 12. Defaults Enabled Command Modes CONFIGURATION Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Power over Ethernet (PoE) 1230