Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 1234

Example Version 9.10(0.0) 9.10(0.0) 9.8(2.0) Description Introduced on the S3148. Increased the stacking range to 12 units in S3100 series. Introduced on the S3100 series. Dell#show power detail stack-unit 1 Unit Total System Redundancy Inline Inline Inline Inline Inline Power Power Power Power Power Power Power Power Available Consumed Consumed Threshold Available Allocated Consumed Remaining (Watts) (Watts) (Watts) (%) (Watts) (Watts) (Watts) (Watts) 1 1100 150 0 10 95 0 0 95 Dell# show power inline You can use this command to display the PoE power allocation on a specified stack unit or on an interface. Syntax Parameters show power inline {stack-unit unit number | interface interface SLOT/PORT [/ SUBPORT] } stack-unit unit number Enter the keyword stack-unit and the stack unit number Range is from 1 to 12. interface interface SLOT/PORT [/ SUBPORT] Enter the interface keyword, and specify the interface type followed by the SLOT/PORT [/SUBPORT] numbers. Defaults Command Modes None • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, refer to the relevant Dell Networking OS Command Line Reference Guide. The following is a list of the Dell Networking OS version history for this command. Version 9.10(0.0) 9.10(0.0) 9.8(2.0) Description Introduced on the S3148. Increased the stacking range to 12 units in S3100 series. Introduced on the S3100 series. Usage Information The following table describes the output fields of the show power inline command: Field Interface Inline Power Allocated Inline Power Consumed Description Displays the line card or the interface slot and port number. Displays the amount of power allocated to the port. Displays the amount of power consumed by the connected device. Power over Ethernet (PoE) 1234