Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 662

Example Example Example (Vlan) • VLAN 20 tagged frames The following describes the do show interfaces command shown in the following example. This example shows output with "Hybrid" as the newly added value for 802.1QTagged. The options for this field are: • True - port is tagged • False - port is untagged • Hybrid - port accepts both tagged and untagged frames The following describes the interface vlan command shown in the following example. This example shows unconfiguration of the hybrid port using the no portmode hybrid command. NOTE: Remove all other configurations on the port before you can remove the hybrid configuration from the port. Dell(conf)# interface gigabitethernet 1/1 Dell(conf-if-gi-1/1)# portmode hybrid Dell(conf-if-gi-1/1)# interface vlan 10 Dell(conf-if-vl-10)# untagged gigabitethernet 1/1 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# tagged gigabitethernet 1/1 Dell(conf-if-vl-20)# Dell(conf-if-vl-20)# do show interfaces switchport Name: GigabitEthernet 1/1 802.1QTagged: Hybrid Vlan membership: Vlan 10, Vlan 20 Native VlanId: 10 Dell(conf-if-vl-20)# Dell(conf-if-vl-20)# interface vlan 10 Dell(conf-if-vl-10)# no untagged gigabitethernet 1/1 Dell(conf-if-vl-10)# interface vlan 20 Dell(conf-if-vl-20)# no tagged gigabitethernet 1/1 Dell(conf-if-vl-20)# interface gigabitethernet 1/1 Dell(conf-if-gi-1/1)# no portmode hybrid Dell(conf-if-vl-20)# rate-interval Configure the traffic sampling interval on the selected interface. Syntax Parameters rate-interval seconds seconds Enter the number of seconds for which to collect traffic data. The range is from 5 to 299 seconds. NOTE: Because polling occurs every 15 seconds, the number of seconds designated here rounds to the multiple of 15 seconds lower than the entered value. For example, if 44 seconds is designated, it rounds to 30; 45 to 59 seconds rounds to 45. Defaults 299 seconds Command Modes INTERFACE Interfaces 662