Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 639

Related Commands • negotiation auto - enable or disables auto-negotiation on an interface. eee Enable Energy-Efficient Ethernet (EEE) on native or optional module copper ports. Syntax eee To disable EEE, use the no eee command. Defaults None. Command Modes INTERFACE Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.1) 9.10(0.0) Description Introduced on the S4820T and S5000. Introduced on the S3100 series. Usage Information EEE is an IEEE 802.3 az standard that reduces power consumptions on Ethernet ports. When EEE is enabled, transmission is stopped when there is no data to be transmitted and is resumed on arrival of new packets. You can enable EEE only on one Gigabit and ten Gigabit native or optional module copper ports. Example To enable EEE: Dell(conf)# interface gigabitethernet 1/1 Dell(conf-if-gi-1/1)# eee To disable EEE: Dell(conf)# interface gigabitethernet 1/1 Dell(conf-if-gi-1/1)# no eee flowcontrol Control how the system responds to and generates 802.3x pause frames. Syntax flowcontrol rx {off | on} tx {off | on} [negotiate | pause-threshold value | resume-offset value] To return to the default, use the no form of this command. Parameters rx on rx off tx on Enter the keywords rx on to process the received flow control frames on this port. Enter the keywords rx off to ignore the received flow control frames on this port. Enter the keywords tx on to send control frames from this port to the connected device when a higher rate of traffic is received. Interfaces 639