Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 194

in | out vrf vrf-name Identify whether ACL is applied on the ingress or egress side. Enter the keyword vrf and then the name of the VRF to display the access-lists that are configured on either the default or non-default VRFs. Command Modes EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 8.5.1.0 8.3.19.0 8.3.11.1 8.3.7.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Added support for the 4-port 40G line cards on the E-Series. Introduced on the S4820T. Introduced on the Z9000. Introduced on the S4810. Standard IP ACL Commands When you create an ACL without any rule and then apply it to an interface, the ACL behavior reflects an implicit permit. The platform supports both Ingress and Egress IP ACLs. NOTE: Also refer to the Commands Common to all ACL Types and Common IP ACL Commands sections. deny To drop packets with a certain IP address, configure a filter. Syntax deny {source | any | host {ip-address}} [no-drop] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny {source [mask] | any | host ip-address} command. Parameters source any Enter the IP address in dotted decimal format of the network from which the packet was sent. Enter the keyword any to specify that all routes are subject to the filter. You can enter any of the following keywords to specify route types. • bytes - Enter the keyword count to count packets the filter processes. • count - Enter the keyword bytesorder to count bytes the filter processes. Access Control Lists (ACL) 194