Dell S3100 Command Line Reference Guide for the Series 9.100.1 - Page 218

Command Modes • EXEC • EXEC Privilege Command History This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) 9.2(1.0) 9.0.2.0 8.3.11.1 8.1.1.0 7.8.1.0 7.6.1.0 7.5.1.0 7.4.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S6000-ON. Introduced on the Z9500. Introduced on the S6000. Introduced on the Z9000. Introduced on the E-Series (IPv4). Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up to 16 characters long. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. Usage Information When all sequence numbers are exhausted, this feature permits re-assigning a new sequence number to entries of an existing access-list. seq Assign a sequence number to a deny or permit filter in an extended IP access list while creating the filter. Syntax Parameters seq sequence-number {deny | permit} {ip-protocol-number | icmp | ip | tcp | udp} {source mask | any | host ip-address} {destination mask | any | host ipaddress} [operator port [port]] [count [byte] | log] [dscp value] [order] [monitor] [fragments] [no-drop] sequencenumber Enter a number from 0 to 4294967290. deny permit ip-protocolnumber Enter the keyword deny to configure a filter to drop packets meeting this condition. Enter the keyword permit to configure a filter to forward packets meeting this criteria. Enter a number from 0 to 255 to filter based on the protocol identified in the IP protocol header. Access Control Lists (ACL) 218