Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 1837

Scanning Multi Band Scan VoIP Aware Scan Power Save Aware Scan Video Aware Scan Ideal Coverage Index Acceptable Coverage Index Free Channel Index Backoff Time Error Rate Threshold Error Rate Wait Time Channel Quality Aware Arm Channel Quality Threshold Channel Quality Wait Time Minimum Scan Time Load aware Scan Threshold Mode Aware Arm Scan Mode Client Match Client Match report interval (sec) Client Match Unsteerable Client Ageout Client Match Unsteerable Client Ageout Interval Client Match Sticky Client Check Interval (sec) Client Match Sticky client check SNR (dB) Client Match SNR threshold(dB) Client Match Sticky Min Signal Client Match Restriction timeout (sec) Client Match Load Balancing threshold (%) Client Match VBR Stale Entry Age (sec) Client Match Max steer failures Client Match Load Balancing client threshold Client Match Load Balancing SNR threshold (dB) Enabled Enabled Enabled Disabled Enabled 10 4 25 240 sec 50 % 30 sec Disabled 70 % 120 sec 8 1250000 Bps Disabled all-reg-domain Enabled 30 Enabled 20 3 25 99 70 255 20 120 5 10 77 The output of this command includes the following parameters: Parameter Assignment Description Displays the current ARM channel/power assignment mode. Allowed bands for 40MHz channels Shows if 40 MHz mode of operation is allowed on the 5 GHz (802.11a) or 2.4 GHz (802.11b/g) frequency band only, on all frequency bands, or on neither frequency band. Client Aware Shows if the client aware feature is enabled or disabled. When enabled, the AP does not change channels when there are active clients. Max Tx Power The highest transmit power levels for the AP, from 0-30 dBm in 3 dBm increments. Higher power level settings may be constrained by local regulatory requirements and AP capabilities. In the event that an AP is configured for a Max Tx Power setting it cannot support, this value will be reduced to the highest supported power setting. Min Tx Power The lowest transmit power levels for the AP, from 0-30 dBm, in 3 dBm increments. Note that power settings will not change if the Assignment option is set to disabled or maintain. 1837 | show rf arm-profile Dell Networking W-Series ArubaOS 6.4.x | User Guide