Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 670

Parameter Description Default wifi-client {decrypted | encrypted | all} Enable or disable packet capturing from a wifi client. Specify the client device by entering the device's MAC address. Disabled Additionally, you can specify what type of traffic captured: decrypted, encrypted, or all. destination Configures the capture destination. - interface or Sends packet captures to a specific interface on the - controller. Specify the interface using the slot/port format or for the W-7200 Series controllers. ip-address Sends packet captures to a specific IP address. - local-filesystem Stores captured packets on the controller in pcap - files. no Negates any configured parameter. Usage Guidelines This command applies to control path packets; not datapath packets. Packets can be retrieved through the tar log command; look for the filter.pcap file. This command activates packet capture options on the current switch. They are not saved and applied across switches. Example The following command sets the default packet capture values to debug a wireless WEP station doing VPN. Once these default settings are defined, you can use the packet-capture command to enable packet capturing with these values. This example uses the following parameters and values: l Station up/down: sysmsg opcode 30 l WEP key plumbing: sysmsg opcode 29 l DHCP: sysmsg opcode 90 l IKE: UDP port 500 and 4500 l Layer 2 Tunneling Protocol (L2TP): UDP port 1701 packet-capture-defaults sysmsg 30,29,90 udp 500,4500,1701,1812,1645 Use the show packet-capture command to show the current action and the default values. (host) show packet-capture Current Active Packet Capture Actions(current switch Packet filtering TCP with 2 port(s) enabled: 2 1 Packet filtering UDP with 1 port(s) enabled: 1 Packet filtering for internal messaging opcodes disabled. Packet filtering for all other packets disabled. Packet Capture Defaults(across switches and reboots if saved) Dell Networking W-Series ArubaOS 6.4.x | User Guide packet-capture-defaults | 670