Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 2326

ap|sta enforce-user-vlan essid g-basic-rates g-beacon-rate g-tx-rates hide-ssid ht-ssid-profile local-probe-req-thresh max-clients Description PEFNG license. Configure this parameter only under the guidance of your Dell representative. Assigns the specified EDCA profile to AP or station (client). Range - Default - Strict enforcement of data traffic only in - user's assigned vlan (Open stations only). Name that uniquely identifies a - wireless network. The ESSID can be up to 31 characters. If the ESSID includes spaces, you must enclose it in quotation marks. - aruba-ap List of supported 802.11b/g rates that are advertised in beacon frames and probe responses. 1, 2, 5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps 1, 2 Mbps Sets the beacon rate for 802.11g (use for Distributed Antenna System (DAS) only). Using this parameter in normal operation may cause connectivity problems. default, 1,2,5, 6 9, 11, 12, 18, 24, 36, 48, 54 Mbps minimum valid rate Set of 802.11b/g rates at which the AP is allowed to send data. The actual transmit rate depends on what the client is able to handle, based on information sent at the time of association and on the current error/loss rate of the client. 1, 2, 5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps 1, 2, 5, 6, 9, 11, 12, 18, 24, 36, 48, 54 Mbps Enables or disables hiding of the SSID - name in beacon frames. Note that hiding the SSID does very little to increase security. disabled Name of high-throughput SSID profile - to use for configuring high-throughput support. See wlan ht-ssid-profile on page 2314. "default" APs will not respond to client probe 0-100 0 requests if the SNR value in the probe request is less than the specified threshold value. Maximum number of wireless clients 0-256 64 for the AP. Dell Networking W-Series ArubaOS 6.4.x | User Guide wlan ssid-profile | 2326