Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 251

Parameter mesh-cluster-profile priority mesh-radio-profile no regulatory-domain-profile rf-optimization-profile virtual-ap voip-cac-profile Description Range Configures the mesh cluster profile for - mesh nodes that are members of the AP group. There is a "default" mesh cluster profile; however, it is not applied until you provision the mesh node. See ap mesh- cluster-profile on page 191. Configures the priority of the mesh cluster profile. If more than two mesh cluster profiles are configured, mesh points use this number to identify primary and backup profile(s). The lower the number, the higher the priority. 1-16 Configures the 802.11g and 802.11a - radio settings for mesh nodes that are members of the AP group. See ap mesh- ht-ssid-profile on page 193. Commands to configure mesh for outdoor APs require the Outdoor Mesh license. Negates any configured parameter. - Configures the country code and valid - channels. See ap regulatory-domain- profile on page 217. Configure coverage hole and interference - detection. See rf optimization-profile on page 782. One or more profiles, each of which - configures a specified WLAN. See wlan virtual-ap on page 2341. Configures voice over IP (VoIP) call - admission control (CAC) options. See wlan voip-cac-profile on page 2354. This parameter requires the PEFNG license. Default "default" 1 "default" - "default" "default" "default" "default" Usage Guidelines AP groups are at the top of the configuration hierarchy. An AP group collects virtual AP definitions and configuration profiles, which are applied to APs in the group. Example The following command configures a virtual AP profile to the "default" AP group: (host)(config) #ap-group default virtual-ap corpnet 251 | ap-group Dell Networking W-Series ArubaOS 6.4.x | User Guide