Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 650

mobility-manager mobility-manager user [interval ] [retrycount ] [udp-port ] [rtls ] trap-version {1|2c|3} Description This command allows the controller to communicate with an MMS server. Usage Guidelines This command needs to be configured before the controller can communicate with the MMS server. This command performs three tasks: l Configures the IP address of the MMS server. In previous ArubaOS releases, this was done with the mobility- server command. l Creates an SNMP version 3 user profile with the configured and . This allows SNMP SETs from the MMS server to be received by the controller. The authentication protocol is Secure Hash Algorithm (SHA) and Data Encryption Standard (DES) is used for encryption. If and match an existing SNMP v3 user profile, the existing one is used. Otherwise, a new profile is created. This username and password must be used when adding this controller to the MMS server in the MMS Dashboard. l Allows SNMP traps and notifications to be sent to the MMS server IP address, by adding this MMS server as a trap receiver. l Optionally enables the MMS server to function as a Real Time Location System (RTLS) server to receive location information via APs from RTLS tags or other devices. Use the show mobility-manager command to check the current status of the configured MMS servers. Example The following command configures the IP address and SNMP user profile for the MMS server: (host) (config)# mobility-manager 10.2.1.245 user mms-user my-password. Command History This command was introduced in ArubaOS 3.1. Command Information Platforms All platforms Licensing Base operating system Command Mode Config mode on master controllers Dell Networking W-Series ArubaOS 6.4.x | User Guide mobility-manager | 650