Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 753

Parameter beacon-period beacon-regulate cap-reg-eirp cell-size-reduction channel Description Range Default Time, in milliseconds, between successive beacon transmissions. The beacon advertises the AP's presence, identity, and radio characteristics to wireless clients. 60 (minimum) 100 milliseconds Enabling this setting introduces - randomness in the beacon generation so that multiple APs on the same channel do not send beacons at the same time, which causes collisions over the air. disabled Work around a known issue on Cisco 7921G telephones by specifying a cap for a radio's maximum equivalent isotropic radiated power (EIRP). When you enable this parameter, even if the regulatory approved maximum for a given channel is higher than this EIRP cap, the AP radio using this profile will advertise only this capped maximum EIRP in its radio beacons. 1-31 dBm. The cell size reduction feature allows you manage dense deployments and to increase overall system performance and capacity by shrinking an AP's receive coverage area, thereby minimizing co-channel interference and optimizing channel reuse. This value should only be changed if the network is experiencing performance issues. The possible range of values for this feature is 0-55 dB. The default 0 dB reduction allows the radio to retain its current default Rx sensitivity value. Values from 1 dB - 55 dB reduce the power level that the radio can hear by that amount. If you configure this feature to use a nondefault value, you must also reduce the radio's transmission (Tx) power to match its new received (Rx) power level. Failure to match a device's Tx power level to its Rx power level can result in a configuration that allows the radio to send messages to a device that it cannot hear. 1-5 5dB 0 dB Channel number for the AP Depends - 802.11a/802.11n.802.11ac physical layer. on The available channels depend on the regulatory regulatory domain (country). Channel domain number configuration options for 20 MHz, 40 MHz, and 80 Mhz modes: l num: Entering a channel number disables 40 MHz mode and activates 20 MHz mode for the entered channel. l num+: Entering a channel number with 753 | rf dot11a-radio-profile Dell Networking W-Series ArubaOS 6.4.x | User Guide