Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 743

Parameter cm-stale-age Description Range The controller maintains client match data for up to clients showing the detected SNR values for up to 16 candidate APs per client. This table is periodically updated as APs send client probe reports to the controller. This parameter defines the amount of time that the controller should retain client match data from each client probe report. Different controller types support varying numbers of clients. l W-650 : 4096 clients l W-3000 Series: 4096 clients l W-7005: 1024 client l W-7010: 2048 clients l W-7030: 4096 clients l W-7240: 32000 clients l W-7220: 24000 clients l W-7210: 16000 clients l W-6000M3 = 8000 clients 0- 65535 seconds cm-steer-timeout When a client is steered from one AP to a more desirable AP, the steer timeout feature helps facilitate the move by defining the amount of time that any APs to which the client should NOT associate will not respond to the AP. 0-255 secs cm-sticky-check-interval Frequency at which the AP checks for client's received SNR values. If the SNR value drops below the threshold defined by the cm-sticky-snr parameter for three consecutive check intervals, that client may be moved to an different AP. 0-255 secs cm-sticky-min-signal A client triggered to move to a different AP may consider an AP radio a better match if the client detects that the signal from the candidate AP radio is at or higher than the minimum signal level defined by this parameterand the candidate radio has a higher signal strength than the radio to which the client is currently associated. (The required improvement in signal strength can be defined using the cm-sticky-snr-delta command.) 0-255 (-dB) Default 900 secs 3 secs 65 743 | rf arm-profile Dell Networking W-Series ArubaOS 6.4.x | User Guide