Dell W-7030 AOS 6.4.x CLI Reference Guide - Page 470

Parameter point-to-point allowed vlan mtu vlan Description NOTE: You must purchase and install the xSec software module license in the controller. Range MAC address of the controller that is the - xSec tunnel termination point, and the 16-byte shared key used to authenticate the controllers to each other. The key must be the same on both controllers. VLANs that are allowed on the xSec - tunnel. (Optional) MTU size for the xSec tunnel. - xSec VLAN ID. For controller-tocontroller communications, both controllers must belong to the same VLAN. 1-4094 Default - - - - Usage Guidelines Use this command to configure settings for the controller interface, including duplex, LLDP and switchport settings. You can issue the show port status command to obtain information about the interfaces currently available on the controller. Interface Bandwidth Contracts W-7000 Series controllers have the ability to classify and identify applications on the network. If a W-7000 Series controller is configured as a branch controller, you can create bandwidth contracts to limit traffic for individual applications (or categories of applications) either sent from or received by a selected interface. There are two basic models for using this feature. l Limiting lower-priority traffic: If there is a lower-priority application or application type that you want to limit, apply a bandwidth contract just to that application, and allow all other application traffic to pass without any limits. l Protecting higher-priority traffic: If you want to guarantee bandwidth for a company-critical application or application group, you can add that application to an exception list, then apply a bandwidth contract to all remaining traffic. You can apply bandwidth contracts using one or both of these models. Each interface supports up to 64 bandwidth contracts. Interface contract Precedence An interface bandwidth contract is applied to downstream traffic before a user-role bandwidth contract is applied, and for upstream traffic, the user-role bandwidth contract is applied before the interface bandwidth contract. For all traffic using compression and encryption, bandwidth contracts are applied after that traffic is compressed and encrypted. If you apply more than one bandwidth contract to any specific category type, then the bandwidth contracts are applied in the following order. 1. A contract that explicitly excludes an application 2. A contract that explicitly excludes an application category 3. A contract that applies to a specific application Dell Networking W-Series ArubaOS 6.4.x | User Guide interface fastethernet | gigabitethernet | 470