Denon ADV-700 Owners Manual - Page 19
Preset memory - remote code
View all Denon ADV-700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
ENGLISH (3) Preset memory [1] Audio Component • The signals of your other Denon products can be stored in the included remote control unit's preset memory to operate either the CDR, MD or TAPE function. Operation is not possible for some models. [2] TV • Other makes of components can be operated by setting the preset memory for your make of TV. This remote control unit can be used to operate components of other manufacturers without using the learning function by registering the manufacturer of the components as shown on the List of Preset Codes (attached sheet). Operation is not possible for some models. CH ON 1 2 3 POWER CH VCR OFF 4 5 6 VCR POWER CH CLEAR 7 TV POWER CH CALL +10 VOL 8 9 TV TV/VCR SLEEP 0 DISPLAY RETURN INPUT MODE SURROUND MENU FUNCTION ENTER 1 1 MODE BAND VOLUME MUTE CH SHIFT NTSC/PAL STATUS TU SUB TITLE AUDIO MEMO ANGLE TOP MENU PROG/DIRECT REPEAT A-B REPEAT RANDOM CH.SELECT T.TONE SDB/TONE SURR.PARA SETUP CDR/MD/TAPE TUNER/TV/VCR DVD REMOCON MODE 1 CH ON 1 2 3 POWER CH VCR OFF 4 5 6 VCR POWER CH CLEAR 7 TV POWER CALL CH +10 VOL 8 9 TV TV/VCR SLEEP 0 DISPLAY RETURN INPUT MODE SURROUND MENU FUNCTION ENTER 1 MODE BAND VOLUME MUTE CH SHIFT NTSC/PAL STATUS TU SUB TITLE AUDIO MEMO ANGLE TOP MENU PROG/DIRECT REPEAT A-B REPEAT RANDOM CH.SELECT T.TONE SDB/TONE SURR.PARA SETUP CDR/MD/TAPE TUNER/TV/VCR DVD REMOCON MODE 1 1 While pressing the CDR/MD/TAPE remote control mode selector button, input the 3-digit number ("000", "111" and "222") corresponding to the device you want to preset (CDR, MD or TAPE), referring to the table below. • Release the CDR/MD/TAPE button after inputting three digits. This completes the presetting operation. Table 1: Combinations of Personal System Codes CDR/MD/TAPE Input the 3-digit number while pressing CDR/MD/TAPE. CDR 0 0 0 MD 1 1 1 TAPE 2 2 2 This is set to CDR by factory default. NOTE: • Only one device (CDR, MD or TAPE) can be stored in the preset memory. 1 Press the CALL button while pressing the TUNER/TV/VCR remote control mode selector button, then input the three- digit number corresponding to the code of the manufacturer of the TV whose signals you want to store, referring to the included list of remote control unit codes. • Release the TUNER/TV/VCR button after inputting three digits. This completes the presetting operation. Example: To preset to "Hitachi 074" TUNER/TV/VCR Press the buttons below while pressing TUNER/TV/VCR. HITACHI "074" TV POWER CALL 0 7 4 This is set to "Hitachi 074" by factory default. NOTE: • Preset codes set upon shipment from the factory and when reset. 19