Denon AVR 3806 Owners Manual - Page 18

Easy Setup and Operation 3 If the check ends, press the ENTER button again. 4 Press the CURSOR D or H button to select whether or not to save the data you have checked. Store: Store the checked measurement values. All parameters are stored. Cancel: Cancel the auto setup settings. 5 Press the CURSOR F button. • After the data is stored, the "Auto Setup / Room EQ" menu screen appears automatically. • When measurements have been made using the measurement microphone, speakers with a built-in filter such as subwoofers might be set with a value that differs from the physical distance because of the internal electrical delay. NOTE: • Do not turn off the power while the data is being stored. If the power is turned off while the data is being stored, the Room EQ parameters stored in the memory will be cleared, and it will not be possible to select the "Audyssey", "Front" or "Flat" equalizer settings. Easy Setup and Operation About the error message These error messages will be displayed when performing the measurements of Auto Setup and the automatic measurements can not be completed because of the speaker arrangement, measurement environment, or other factors. Please check the following matters, reset the pertinent items, and measure again. Be sure to turn off the AVR-3806's power before checking the speaker connections. Screen example Cause Measures q The speakers required for producing suitable • Check that the pertinent speakers are properly reproduction have not been detected. connected. • The front L and front R speakers were not properly detected. • Only one channel of the surround (A) and surround (B) speakers was detected. • Sound was output from the R channel when only one surround back speaker was connected. • The surround back or the surround (B) speaker was detected, but the surround (A) speaker was not detected. If multiple errors occur, press the CURSOR F or G button to check the contents. w The speaker polarity is connected in reverse. • Check the polarity of the pertinent speakers. • For some speakers, the screen below may be If multiple errors occur, press the CURSOR F or G button displayed even though the speakers are to check the contents. properly connected. If so, select "Skip0". e There is too much ambient noise in the room and the • Either turn off the power of the device that measurements cannot be made accurately. generated the noise during the measurements or move the device away. • Try again at a time when it is quieter. r The sound level that is output from the speakers and/or • Check the placement and orientation of the subwoofer is too low. loudspeakers. • Adjust the subwoofer's output level. t The measurement microphone is not connected, or all • Connect the measurement microphone to the of speakers have not been detected. microphone connector. • Check the speaker connection. Playing a DVD with surround sound 1 Disconnect the microphone from the unit. 3 Select the play (surround) mode. 2 Select the input source to be played. 4 Start DVD playback. 13 5 Adjust the volume.