Denon AVR 3806 Owners Manual - Page 82

Advanced Setup - Part 2 4 Press the CURSORF or G button to set the distance between the center speaker and listening position. Example: When the distance is set to 10 feet for the center speaker Setting the Channel Level • Use this setting to adjust so that the playback level between the different channels is equal. • From the listening position, listen to the test tones produced from the speakers to adjust the level. 1 Press the CURSOR D or H button to select the "Channel Level" at the "Speaker Setup" menu, then press the ENTER button. • The "Channel Level" screen appears. Advanced Setup - Part 2 Surr. Sp. : A Adjusts the balance of the playback level between the channels when using surround speaker A. Surr. Sp. : B Adjusts the balance of the playback level between the channels when using surround speaker B. Surr. Sp. : A + B Adjusts the balance of the playback level between the channels when using surround speakers A and B at the same time. The distance changes in units of 0.1 foot (0.03 meters) or 1 foot (0.3 meters) each time the button is pressed. Select the value closest to the measured distance. If "Yes" is selected for "Default", the settings are automatically reset to the default values. When "Step" is selected, you can select the unit of "1 ft (0.1 m)" or "0.1 ft (0.01 m)". Please note that the difference of distance for every speaker should be 20 ft (6.0 m) or less. If you set an invalid distance, a CAUTION notice, such as screen right will appear. In this case, please relocate the blinking speaker(s) so that its distance is no larger than the value shown in highlighted line. 5 Press the ENTER button to enter the setting. • The "Speaker Setup" menu reappears. The AVR-3806 automatically sets the optimum surround delay time for the listening room. 2 Press the CURSOR F or G button to select the "Auto" or "Manual". Auto: Adjust the level while listening to the test tones produced automatically from each speaker. Test tones are automatically emitted from each speaker. Manual: Select the speaker from which you want to produce the test tone to adjust the level. Example: When the "Auto" mode is selected 3 Press the CURSOR D or H button to select the "Surr. Sp.", then press the CURSOR F or G button to select the surround speaker(s) from which you want to produce the test tone (A, B or A+B). The "Surr. Sp." can only be selected when both surround speakers A and B have been selected at the System Setup Menu (when both A and B have been set to "Large" or "Small"). 4 Press the CURSOR D or H button to select the "Test Tone Start", then press the CURSOR F button to select the "Yes". 5 When "Auto" mode is selected: Press the CURSOR F or G button to adjust all -1 the speakers to the same volume. • The test tones are emitted from each speaker in the following order, at 4-second intervals during the first and second time, and at the 2-second intervals during the third and subsequent cycles: FL C FR SR 2spkrs SW SL SBL SBR SB 1spkr When the surround back speaker setting is set to "1spkr" for "Speaker Configuration", this is set to "SB". 77