Epson 890N Service Manual - Page 89
Carriage Assembly Removal 2, When attaching the TIMING BELT to the Carriage Assembly
UPC - 010343850019
View all Epson 890N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 89 highlights
EPSON FX-890/2190 7. Move the Carriage Assembly to the right end, and remove it from the rack of the FRAME,FRONT with the SHAFT,CR,GUIDE. (See Figure 4-27) 8. Release the TIMING BELT from the 2 clips at the bottom of the Carriage Assembly. A D JU S TM E N T R E Q U IR E D After installing the Carriage Assembly, make the following adjustments: • Bi-d Adjustment (p.101) • Platen Gap Adjustment (p.95) Lubrication is necessary at three points. (For details, refer to "Lubrication" (p.100) in Chapter 6.) When attaching the TIMING BELT to the Carriage Assembly, secure the TIMING BELT with the left and right clips in the Carriage Assembly, as shown below, and ensure there is no slack in the TIMING BELT. Clip TIMING BELT Make sure that the groove for the rail in the front of the Carriage Assembly is fitted on the rail of the FRAME, FRONT. SHAFT, CR, GUIDE Carriage Assembly Revision B Clips TIMING BELT Frame, FRONT Disassembly and Assembly Figure 4-27. Carriage Assembly Removal 2 Printer Mechanism Disassembly 89