Epson ActionDesk 4000 User Manual - Page 62
Refer to the illustrations below and follow these steps to install
View all Epson ActionDesk 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Check the components on your option card and the system board before deciding which slot to use. Make sure that no components are touching or obstructing other cards or cables. Caution Make sure the power requirements for the option cards you install do not exceed the power supply limitations. See your option card manual(s) for the power requirements. Then check Appendix A for the option slot power limits. Before you install an option card, see if you need to change any jumper settings on the system board. For example, if you install a SCSI hard disk drive, you may need to change jumper J35 to disable the IDE hard disk drive controller. See page 4-6 for more information on jumpers. Note You cannot install a video display card in this system. Refer to the illustrations below and follow these steps to install an option card: 1. If you are using a 16-bit option slot, go on to step 2. If you are using an 8-bit slot near the power supply, you need to move the power supply before you can remove the metal slot cover. Installing and Removing Options 4-15