Epson ActionDesk 4000 User Manual - Page 69
Caution, Position one of the ZIP chips over the first empty socket U2
![]() |
View all Epson ActionDesk 4000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Caution To avoid generating static electricity and damaging the memory chips, ground yourself by touching the metal surface on the inside of the computer's back panel. Then remain as stationary as possible while you install them. 3. Remove the memory chips from their package and inspect each one. The pins should point inward at slightly less than a 90° angle. If any of the pins are bent or crooked, straighten them gently with your fingers or with small tweezers to align them with the other pins. Be careful when you do this; the pins are fragile and can break off easily. 4. Position one of the ZIP chips over the first empty socket (U2) as shown below, aligning the pins on the chip with the holes in the socket. 5. Gently press the chip halfway into the socket (to make sure it is correctly aligned). If the chip does not go in smoothly, remove it and try again. 4-22 Installing and Removing Options
![](/manual_guide/products/epson-actiondesk-4000-user-manual-edf8518/69.png)