Epson Endeavor User Manual - Page 39
USING A PASSWORD, CHANGING OR DELETING A PASSWORD, Changing, a Password
View all Epson Endeavor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Using a Password If you set a System Access password when you ran the SETUP program, you must enter it every time you turn on or reset the computer. Follow these steps to use your password: 1. If you do not have a hard disk, insert your system diskette in drive A. 2. Turn on or reset the computer. You see the following prompt: Enter Password: 3. Type your password. You see an asterisk for each character you type. Then press [Enter]. After you type the password correctly and press [=I, the computer loads the operating system and displays the command prompt. Note If you do not know the correct password, see "Password Problems" in Chapter 6. Changing or Deleting a Password To change or delete your password, you must run the SETUP program and follow the instructions for entering a password in Chapter 2 of the Setup Guide. If you do not know your password, see "Password Problems" in Chapter 6. Using Your Computer 1-23