Epson Endeavor User Manual - Page 98
with the gap in the drive connector, as shown below.
View all Epson Endeavor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 98 highlights
1. Locate the diskette drive ribbon cable. One end of the cable is connected to the system board. If you are installing a second diskette drive in the lower horizontal drive bay, the other end of the cable is connected to the top diskette drive; use the middle connector. If you are installing a diskette drive in the upper bay, use the free end connector. The diskette drive connector that extends from the back of the drive has gold contacts on both sides. Grasp the cable connector and align it with the drive connector so that the key-way (the plastic divider) in the cable connector lines up with the gap in the drive connector, as shown below. key-way Make sure the cable connector fits properly onto the drive connector and push it into place. Then go to step 3. Caution If you do not align the connector correctly, you could severely damage your drive when you push it in. Installing and Removing Drives 3-25