HP 2300d Service Manual - Page 63

Print-quality submenu Some items on this menu are available in the program or printer driver (if the appropriate driver is installed). Program and printer-driver settings override control-panel settings. In general, it is best to change these settings in the printer driver, if applicable. The following table lists the settings and possible values. In the Values column, the default value for each setting is the one with an asterisk (*) next to it. Table 13. Configure device menu-print-quality submenu Item Values Explanation SET REGISTRATION There is no value to select. Shifts the margin alignment to center the image on the page from top to bottom, and left to right. You can also align the image that is printed on the front with the image that is printed on the back. PRINT TEST PAGE There is no value to Prints a test page to show the current registration settings. select. SOURCE ALL TRAYS TRAY 1 *TRAY 2 TRAY 3 Selects the tray for which you want to print the test page. ADJUST TRAY [N] X1 Shift X2 Shift Y Shift -20 to 20 (*0) Sets the registration for the specified tray, where [N] is the number of the tray. A selection appears for each tray that is installed, and registration must be set for each tray. q X1 SHIFT: Registration of the image on the paper from side to side, as the paper lies in the tray. For duplexing, this side is the second side (back) of the paper. q X2 SHIFT: Registration of the image on the paper from side to side, as the paper lies in the tray, for the first side (front) of a duplexed page. This item appears only if the printer includes a built-in duplexer (HP LaserJet 2300d printer, HP LaserJet 2300dn printer, and HP LaserJet 2300dtn printer) and DUPLEX=ON (see "DUPLEX" on page 59). Set the X1 SHIFT first. q Y SHIFT: Registration of the image on the paper from top to bottom as the paper lies in the tray. ENWW Chapter 3 Operation 61