HP 2610 User Guide - Page 103

Chapter 10 successfully and use your PC modem. (A parallel splitter has one RJ-11 port on the front and two RJ-11 ports on the back. Do not use a 2-line phone splitter, a serial splitter, or a parallel splitter which has two RJ-11 ports on the front and a plug on the back.) You will also need three additional phone cords. You can purchase a parallel splitter and additional phone cords from an electronics store. ● If your computer has two phone ports, see Set up your HP all-in-one to a computer with two phone ports. Set up your HP all-in-one to a computer with one phone port This section describes how to set up your HP all-in-one with a PC modem if your computer has only one phone port. Fax setup Back view of the HP all-in-one 1 Telephone wall jack 2 Phone cord connected to the "2-EXT" port 3 Parallel splitter 4 Telephone 5 Computer with modem 6 Phone cord supplied in the box with your HP all-in-one connected to the "1-LINE" port To set up your HP all-in-one to a computer with one phone port 1 Find the phone cord that connects from the back of your computer (your PC modem) to a telephone wall jack. Disconnect the cord from the telephone wall jack and plug it into the parallel splitter on the side with two phone ports. 2 Using another phone cord, connect one end to the port labeled "2-EXT" on the back of your HP all-in-one. Connect the other end of the phone cord to the parallel splitter on the side with the single phone port. 3 Using the phone cord supplied in the box with your HP all-in-one, connect one end to your telephone wall jack, then connect the other end to the port labeled "1-LINE" on the back of your HP all-in-one. Caution If you do not use the supplied cord to connect from the telephone wall jack to your HP all-in-one, you might not be able to fax successfully. This special phone cord is different from the phone cords you might already have in your home or office. If the supplied phone cord is too short, see The 100 HP Photosmart 2600/2700 series all-in-one