HP 6120XG HP ProCurve Series 6120 Blade Switches IPv6 Configuration Guide - Page 158
Syntax, ipv6-address, link-local-address, vlan-id, hostname, Default, Range
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
IPv6 Diagnostic and Troubleshooting Traceroute for IPv6 Syntax: traceroute6 < ipv6-address | hostname > [minttl < 1-255 > [maxttl < 1-255 > [timeout < 1 - 60 >] [probes < 1-5 >] [source < ipv6-addr | vid | oobm> traceroute6 [minttl < 1-255 >] [maxttl < 1-255 >] [timeout < 1 - 60 >] [probes < 1-5 >] [source < ipv6-addr | vid | oobm> Lists the IPv6 address of each hop in the route to the specified destination host device with the time (in microseconds) required for a packet reply to be received from each next-hop device. : IPv6 address of a destination host device. %vlan: IPv6 link-local address, where %vlan specifies the VLAN ID number. : Host name of an IPv6 host device configured on an IPv6 DNS server. < oobm >: For switches that have a separate out-of-band management (OOBM) port, oobm specifies that the traffic originates from the out-of-band management port. minttl: Minimum number of hops allowed for each probe packet sent along the route. Default: 1; Range: 1 - 255. • If the minttl value is greater than the actual number of hops, the traceroute output displays only the hops equal to or greater than the configured minttl threshold value. The hops below the threshold value are not displayed. • If the minttl value is the same as the actual number of hops, only the final hop is displayed in the command output. • If the minttl value is less than the actual number of hops, all hops to the destination host are displayed. maxttl: Maximum number of hops allowed for each probe packet sent along the route. Valid values: 1 - 255. Default: 30. • If the maxttl value is less than the actual number of hops required to reach the host, the traceroute output displays only the IPv6 addresses of the hops detected by the configured maxttl value. 7-6