HP 6120XG HP ProCurve Series 6120 Blade Switches IPv6 Configuration Guide - Page 164
Debug Command, Syntax
View all HP 6120XG manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 164 highlights
IPv6 Diagnostic and Troubleshooting Debug/Syslog for IPv6 Debug Command Syntax: [no] debug < debug-type > Configures the types of IPv4 and IPv6 messages that are sent to Syslog servers or other debug destinations, where is any of the following event types: all Configures all IPv4 and IPv6 debug message types to be sent to configured debug destinations. (Default: Disabled - No debug messages are sent.) arp-protect Configures messages for Dynamic ARP Protection events to be sent to configured debug destinations. (Default: Disabled - No debug messages are sent.) event Configures Event Log messages to be sent to configured debug destinations. Event Log messages are enabled to be automatically sent to debug destinations in the following conditions: • If no Syslog server address is configured and you enter the logging command to configure a destination address. • If at least one Syslog server address is configured in the startup configuration and the switch is rebooted or reset. Event log messages are the default type of debug message sent to configured debug destinations. ip Configures IPv4 OSPF and RIP routing messages to be sent to configured debug destinations. Syntax:. [no] debug < debug-type > (Continued) ip [ ospf < adj | event | flood | lsa-generation | packet | retransmission | spf > ] Configures specified IPv4 OSPF message types to be sent to configured debug destinations: adj - Adjacency changes. event - OSPF events. flood - Information on flood messages. lsa-generation - New LSAs added to database. packet - Packets sent/received. retransmission - Retransmission timer messages. spf - Path recalculation messages 7-12